


We would very much like to provide you with a helpful search result.
In order to refine the search, you should enter a search term containing at least three characters.
22 x rated
Link tip:
Bosch reserves the right to revoke the consent for linking and/or embedding contents of the Bosch website to external sites in individual cases or in general. Linking or embedding Bosch contents on sites with dubious contents is prohibited.
Close window
You have to choose different drill bits and drilling methods depending on the material you want to work on. Here you will find out what each drill bit is suitable for.
You have to choose different drill bits and drilling methods depending on the material you want to work on. Here you will find out what each drill bit is suitable for.
HSS drill bits with a partially ground tip are suitable for non-ferrous metals. These include aluminium, copper, brass, zinc, iron and non-alloyed steel. Drill bits made of cobalt-alloyed High Speed Steel (HSS-E) or even drill bits with titanium coating are required for stainless steel. They are more expensive than normal HSS drill bits but they enable drilling in special steel without a high level of drill bit wear.
Brad point drill bits have a long centring tip with two pre-cutting spurs. These spurs score the wood fibres; the internal cutting edges then cut them out cleanly. Forstner drill bits, hardware drill bits or hinge cutting bits are usually used for larger drill bit diameters; there are auger bits for deep holes in wood.
Masonry made of clinker, brick or concrete requires an impact drill or a rotary hammer to be used. However, if the wall consists of perforated stones with porous material, only rotary drilling is performed (i.e. without impact). The same applies to porous bricks and boarded walls. A masonry drill bit is required for all work in these materials. It has soldered-in tungsten-carbide plates on the drill bit tip.
Close window
The data entrusted to Bosch shall be stored and processed electronically in accordance with legal stipulations and only used for the comment function on the Bosch Power Tool website.
Any further use of the data shall only take place when you explicitly declare that you agree to be notified about more information and current offers. In this case, you declare that you agree to your data being used for information and support purposes by Bosch. This consent can be revoked at any time for the future.
To do this, please get in touch with our central contact office using the contact link at the top of the page.
If you have any questions regarding data protection, please contact our data security engineer. Contact information can be found in the imprint.
Comments at Bosch are accessible to the public. We collect and store the following personal data:
- e-mail address
- First name, Surname
- Your comment
The data is not passed on to third parties. You can inquire at any time about the data stored about you, and have it changed and/or deleted.
To do this, please get in touch with our central contact office using the contact link at the top of the page.
If the contents of comments are libel, discriminating or violate the rights of third parties, you can report these comments directly to Bosch using the "Report violation" link.
Bosch will investigate all reported comments and does not accept liability for entries by third parties.
In order to prevent misuse of this service, Bosch shall store for a brief time the identification data (IP address) of every user who writes a comment.
Bosch reserves the right to delete contents without stating a reason.
If third parties show credibly that their rights have been violated by an entry made as part of this service, Bosch shall release the identification data for legal prosecution.
Thank you very much for the comment. To post it, please check your mails and confirm the link we have sent to you.
Thank you very much for the notification. We will attend to your notification immediately.
Der betroffene Kommentar wird in Kürze automatisch gelöscht werden.
Your comment will shortly be posted on this page.